Не работает сеть в msi x410. Драйвер качал и собирал из сайта Риалтека. Все прошло успешно, но сеть так и не появилась.
$ uname -a
Linux decdb 2.6.32-5-amd64 #1 SMP Sun May 6 04:00:17 UTC 2012 x86_64 GNU/Linux
$ sudo lspci -v
02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8101E/RTL8102E PCI Express Fast Ethernet controller (rev 02)
Subsystem: Micro-Star International Co., Ltd. Device 1028
Flags: bus master, fast devsel, latency 0, IRQ 16
I/O ports at e800 [size=256]
Memory at fdfff000 (64-bit, prefetchable) [size=4K]
Memory at fdfe0000 (64-bit, prefetchable) [size=64K]
[virtual] Expansion ROM at feae0000 [disabled] [size=128K]
Capabilities: [40] Power Management version 3
Capabilities: [50] MSI: Enable- Count=1/1 Maskable- 64bit+
Capabilities: [70] Express Endpoint, MSI 01
Capabilities: [ac] MSI-X: Enable- Count=2 Masked-
Capabilities: [cc] Vital Product Data
Capabilities: [100] Advanced Error Reporting
Capabilities: [140] Virtual Channel
Capabilities: [160] Device Serial Number 01-00-00-00-00-00-00-00
Kernel driver in use: r8101
Subsystem: Micro-Star International Co., Ltd. Device 1028
Flags: bus master, fast devsel, latency 0, IRQ 16
I/O ports at e800 [size=256]
Memory at fdfff000 (64-bit, prefetchable) [size=4K]
Memory at fdfe0000 (64-bit, prefetchable) [size=64K]
[virtual] Expansion ROM at feae0000 [disabled] [size=128K]
Capabilities: [40] Power Management version 3
Capabilities: [50] MSI: Enable- Count=1/1 Maskable- 64bit+
Capabilities: [70] Express Endpoint, MSI 01
Capabilities: [ac] MSI-X: Enable- Count=2 Masked-
Capabilities: [cc] Vital Product Data
Capabilities: [100] Advanced Error Reporting
Capabilities: [140] Virtual Channel
Capabilities: [160] Device Serial Number 01-00-00-00-00-00-00-00
Kernel driver in use: r8101
$ lsmod | grep r8
r8101 77595 0
$ sudo ifconfig eth0
eth0 Link encap:Ethernet HWaddr 00:24:21:69:b6:7f
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:16 Base address:0xe000
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:16 Base address:0xe000
Как видим, попытки подключить кабель безуспешны:
$ dmesg | grep eth0
[ 0.949262] eth0: Identified chip type is 'RTL8103E'.
[ 0.949266] eth0: RTL8101E at 0xffffc9000031e000, 00:24:21:69:b6:7f, IRQ 16
[ 28.176261] r8101: eth0: link down
[ 28.201426] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 437.401069] r8101: eth0: link up
[ 437.402280] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 441.951313] r8101: eth0: link down
[ 443.723767] r8101: eth0: link up
[ 448.176046] eth0: no IPv6 routers present
[ 448.237953] r8101: eth0: link down
[ 448.241601] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 449.752869] r8101: eth0: link up
[ 449.754056] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 450.603324] r8101: eth0: link down
[ 450.605148] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 450.676498] r8101: eth0: link down
[ 450.677920] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 0.949266] eth0: RTL8101E at 0xffffc9000031e000, 00:24:21:69:b6:7f, IRQ 16
[ 28.176261] r8101: eth0: link down
[ 28.201426] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 437.401069] r8101: eth0: link up
[ 437.402280] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 441.951313] r8101: eth0: link down
[ 443.723767] r8101: eth0: link up
[ 448.176046] eth0: no IPv6 routers present
[ 448.237953] r8101: eth0: link down
[ 448.241601] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 449.752869] r8101: eth0: link up
[ 449.754056] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 450.603324] r8101: eth0: link down
[ 450.605148] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 450.676498] r8101: eth0: link down
[ 450.677920] ADDRCONF(NETDEV_UP): eth0: link is not ready
