Kde vs wifi

Доброго вечера.
свежеустановленная система debian testing wheezy
[console]# uname -a
Linux moshell 3.2.0-1-amd64 #1 SMP Sun Feb 5 15:17:15 UTC 2012 x86_64 GNU/Linux
# uname[/console]
так как b43 не идет на карте
[console]# lspci -vnn | grep 14e4
02:00.0 Network controller [0280]: Broadcom Corporation BCM4313 802.11b/g/n Wireless LAN Controller [14e4:4727] (rev 01)
Subsystem: Broadcom Corporation Device [14e4:051b]
#[/console]
решил использовать brcm80211
ставил по этому мануалу
проверяю
[console]# ifconfig -a
eth0 Link encap:Ethernet HWaddr f0:de:f1:51:27:8e
inet addr:192.168.0.5 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::f2de:f1ff:fe51:278e/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1955 errors:0 dropped:0 overruns:0 frame:0
TX packets:2013 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1688995 (1.6 MiB) TX bytes:479521 (468.2 KiB)
Interrupt:40 Base address:0x2000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:108 errors:0 dropped:0 overruns:0 frame:0
TX packets:108 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:8120 (7.9 KiB) TX bytes:8120 (7.9 KiB)

wlan0 Link encap:Ethernet HWaddr c0:f8:da:2b:3b:a4
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

# iwconfig
lo no wireless extensions.

wlan0 IEEE 802.11bgn ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=19 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off

eth0 no wireless extensions.
#[/console]
когда пытаюсь поставить галку в network manager "enable wireless", то в dmesg получаю следующее
[console][ 152.391689] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 154.022448] ieee80211 phy0: brcms_ops_config: change monitor mode: false (implement)
[ 154.022454] ieee80211 phy0: brcms_ops_config: change power-save mode: false (implement)
[ 154.023457] ieee80211 phy0: brcms_ops_bss_info_changed: qos enabled: false (implement)
[ 154.023796] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 155.186177] eth0: no IPv6 routers present
[ 738.018391] ieee80211 phy0: brcms_ops_config: change monitor mode: false (implement)
[ 738.018397] ieee80211 phy0: brcms_ops_config: change power-save mode: false (implement)
[ 738.019417] ieee80211 phy0: brcms_ops_bss_info_changed: qos enabled: false (implement)
[ 738.019797] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 767.888771] ieee80211 phy0: brcms_ops_config: change monitor mode: false (implement)
[ 767.888777] ieee80211 phy0: brcms_ops_config: change power-save mode: false (implement)
[ 767.889792] ieee80211 phy0: brcms_ops_bss_info_changed: qos enabled: false (implement)
[ 767.890137] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 769.620725] ieee80211 phy0: brcms_ops_config: change monitor mode: false (implement)
[ 769.620731] ieee80211 phy0: brcms_ops_config: change power-save mode: false (implement)
[ 769.621740] ieee80211 phy0: brcms_ops_bss_info_changed: qos enabled: false (implement)
[ 769.622083] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 771.042131] ieee80211 phy0: brcms_ops_config: change monitor mode: false (implement)
[ 771.042136] ieee80211 phy0: brcms_ops_config: change power-save mode: false (implement)
[ 771.045536] ieee80211 phy0: brcms_ops_bss_info_changed: qos enabled: false (implement)
[ 771.045877] ADDRCONF(NETDEV_UP): wlan0: link is not ready[/console]
гуглил проблему, нашел следующее, не помогло
юзер в группе netdev

вот другие настройки
[console]# cat /etc/NetworkManager/NetworkManager.conf
[main]
plugins=ifupdown,keyfile

[ifupdown]
managed=true
# cat /etc/network/interfaces
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).

# The loopback network interface
auto lo
iface lo inet loopback

# The primary network interface
allow-hotplug eth0
#NetworkManager#iface eth0 inet dhcp

#[/console]

[console]# lsmod | grep brc
brcmsmac 473849 0
mac80211 192768 1 brcmsmac
brcmutil 12905 1 brcmsmac
cfg80211 137140 2 brcmsmac,mac80211
crc8 12426 1 brcmsmac
cordic 12313 1 brcmsmac
#
[/console]

что я сделал не так?

сети то сканирует, значит карта в принципе может работать
[console]# iwlist wlan0 scan | grep ESSID
ESSID:"boo"
ESSID:"kobin"
ESSID:"masonik"
ESSID:"kb"
ESSID:"123"
ESSID:"\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00"
#[/console]

[console]# lspci -k
00:00.0 Host bridge: Intel Corporation 2nd Generation Core Processor Family DRAM Controller (rev 09)
Subsystem: Lenovo Device 3975
Kernel driver in use: agpgart-intel
00:02.0 VGA compatible controller: Intel Corporation 2nd Generation Core Processor Family Integrated Graphics Controller (rev 09)
Subsystem: Lenovo Device 397d
Kernel driver in use: i915
00:16.0 Communication controller: Intel Corporation 6 Series/C200 Series Chipset Family MEI Controller #1 (rev 04)
Subsystem: Lenovo Device 3975
00:1a.0 USB controller: Intel Corporation 6 Series/C200 Series Chipset Family USB Enhanced Host Controller #2 (rev 05)
Subsystem: Lenovo Device 3975
Kernel driver in use: ehci_hcd
00:1b.0 Audio device: Intel Corporation 6 Series/C200 Series Chipset Family High Definition Audio Controller (rev 05)
Subsystem: Lenovo Device 3975
Kernel driver in use: snd_hda_intel
00:1c.0 PCI bridge: Intel Corporation 6 Series/C200 Series Chipset Family PCI Express Root Port 1 (rev b5)
Kernel driver in use: pcieport
00:1c.1 PCI bridge: Intel Corporation 6 Series/C200 Series Chipset Family PCI Express Root Port 2 (rev b5)
Kernel driver in use: pcieport
00:1c.3 PCI bridge: Intel Corporation 6 Series/C200 Series Chipset Family PCI Express Root Port 4 (rev b5)
Kernel driver in use: pcieport
00:1d.0 USB controller: Intel Corporation 6 Series/C200 Series Chipset Family USB Enhanced Host Controller #1 (rev 05)
Subsystem: Lenovo Device 3975
Kernel driver in use: ehci_hcd
00:1f.0 ISA bridge: Intel Corporation HM65 Express Chipset Family LPC Controller (rev 05)
Subsystem: Lenovo Device 3975
00:1f.2 SATA controller: Intel Corporation 6 Series/C200 Series Chipset Family 6 port SATA AHCI Controller (rev 05)
Subsystem: Lenovo Device 3975
Kernel driver in use: ahci
00:1f.3 SMBus: Intel Corporation 6 Series/C200 Series Chipset Family SMBus Controller (rev 05)
Subsystem: Lenovo Device 3975
02:00.0 Network controller: Broadcom Corporation BCM4313 802.11b/g/n Wireless LAN Controller (rev 01)
Subsystem: Broadcom Corporation Device 051b
Kernel driver in use: brcmsmac
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 06)
Subsystem: Lenovo Device 3975
Kernel driver in use: r8169
#[/console]

У меня гном, и стандартный нетворкменеджер, при включении wifi тут же его отключает обратно, из терминала и интерфейс могу поднять и сети сканирует и подключается, все нормально. Поставил wicd, вот через него сеть нормально и подмается и подключается. Попробуй. может поможет.

PantiL, предлагаете отпилить нет-манагер и запилить wicd?

Можешь попробовать этот драйвер: http://wiki.debian.org/wl

мимо пробегал

Для начала просто попробуй wicd, он нормально будет искать сеть и подключаться или как?

У меня стандартный манегер так и присутствует в системе, никак не отпилю. Хотя пользуюсь wicd

tunix23, этот драйвер не работает с моей картой, официально заявлено
no (WIP) work in process

PantiL, прежде отпилил этот манагер, и запилил wicd, благо диск при мне.
все работает, пишу с вайфая.

зы. висд продвинутее?

можно вешать гриф "решено"